Categories
Machining

Mill delivered and roughly put together!

I got the mill out of the box and bolted together. No calibration or leveling yet, but that will come in subsequent videos. Enjoy!

By Chris Gammell

Chris Gammell is an engineer who talks more than most other engineers. He also writes, makes videos and a couple podcasts. While analog electronics happen to be his primary interests, he also dablles in FPGAs and system level design.

One reply on “Mill delivered and roughly put together!”

Nice mill Chris – I’ve always heard good things about the Taig mill / lathe. Very well made 🙂

I bought a run of the mill (no pun intended) X2 a while back and while it seems to work well, there’s no comparison in build quality. You get what you pay for 😉

Comments are closed.