Categories
Machining

First cut on the mill

This is the first time I try cutting anything on the new mill. It’s also the first time I have a full beard on camera (and last!).

The result was mediocre but acceptable for a first try. Stay tuned to see more cuts!

Categories
Mechanical

Disassembling and Reassembling a Mill

If it hasn’t already been painfully obvious, I’m trying to learn mechanical stuff. Odd for a site that’s supposed to be about electronics, but I’ll get back to that on here eventually. Hopefully you’ll stick around until then. I’ve found that working with the mill has me looking at mechanical problems in a completely different light and has made me a better system designer overall.

As for these videos, I took the whole thing apart, mounted the base to my bench, put it back together, oiled it (not shown in video), leveled it and attached the stepper motors. I now have a functional machine!

Thanks to megananne for the featured image photo

Categories
Mechanical

Introduction to my CNC Setup

This video is showing all of the gear I purchased in preparation for getting my CNC mill up and running. This video shows just about everything except the mill, which will arrive tomorrow. Check out the links below to see all of the stuff I bought, in the event you’d like to purchase some or all of the same gear.

Many thanks to everyone who helped me along so far! I really appreciate it, even though I can’t take everyone’s advice all at once. I hope things continue to get more exciting!